Hot-Spark Ignition Products - Conversion Kits Nederlands Deutsch English

- Installationshinweise -


Schnelle installation
- Entferen Sie die Unterbrecherkontakte und den Kondensator.
- Montieren Sie den Hot-Spark-Satz und montieren Sie den Magnetring um die Ankerwelle.
- Überzeugen Sie sich davon das die Kabel im Verteiler frei liegen und keine bewegenden Teile berühren.
- Verbinden Sie das rote Kabel vom Hot-Spark Modul an der positiven Elektrode der Zündspule ( + oder 15 auf der spule).
- Verbinden Sie das schwarze Kabel vom Hot-Spark Modul an der negativen Elektrode der Zündspule ( - oder 1 auf der Spule).
- Starten Sie den Motor (vielleicht soll der Verteiler zuerst etwas verdreht werden).
- Justieren Sie die Zündung weiter mit einem Stroboskop.

Hot-Spark bedrading diagram
Achtung
Hot-Spark-Sätze sind für 12V mit normale negative Masse.
Umpolen des roten und schwarzen Kabels zerstört den Bausatz und dadurch verfällt die Garantie.


Für detailierte installation instructions (englisch):
- Installieren des Hot-Spark-Sätzes für Bosch Verteiler
- Installieren des Hot-Spark-Sätzes für GM / Delco Verteiler
- Installieren des Hot-Spark-Sätzes für Ford / Mercury Verteiler
- Installieren des SVDA 009 Verteiler
- Installieren des SVDA 034 Verteiler
- Timing diagram für SVDA 009 Verteiler
- Timing diagram für SVDA 034 Verteiler
- Probleme lösen




- Klicken Sie bitte hier um zum WEBSHOP zu gelangen -
- Klicken Sie bitte hier um zur Hauptseite zurückzukehren -
- E-mail: info@hot-spark.eu -




Disclaimer
Hot-Spark Ignition Products warrants its electronic ignition conversion kits to be free from defects in material and workmanship under normal use and if properly installed for a period of three years from date of purchase. If found to be defective as mentioned above, it will be replaced or repaired if returned prepaid along with proof of date of purchase. Warranty shall be null and void if it is determined that said electronic ignition conversion kit has been connected improperly, if it is used with an ignition coil which has insufficient resistance in its primary circuit, if the electronic ignition kit has been subjected to more than 14.2 volts or 4.0 amps of electrical current or if the polarity of the electrical wiring of the ignition kit has been reversed. Hot-Spark Ignition Products warrants its ignition distributors to be free from defects in material and workmanship under normal use and if properly installed for a period of ninety (90) days from date of purchase. If found to be defective as mentioned above, distributor will be replaced or repaired if returned prepaid along with proof of date of purchase. This shall constitute the sole remedy of the purchaser and the sole liability of Hot-Spark Ignition Products. To the extent permitted by law, the foregoing is exclusive and in lieu of all other warranties or representations whether expressed or implied, including any implied warranty of merchantability or fitness. In no event shall Hot-Spark Ignition Products be liable for special or consequential damages.


Website and contents © Copyright Hot-Spark 2008.